NIBP Monitoring
12-4
12.5 Display NIBP List
You can display multiple sets of NIBP results measured recently in the parameter area by the following steps:
1) Enter [Tile Layout] in any of the following ways:
Select [Screen Setup] hot key → [Tile Layout]
Select [Main Menu] hot key → [Display] → [Tile Layout].
2) Click on the area where NIBP list is to be displayed, and select [NIBP] → [NIBP List] from the drop-down list.
12.6 NIBP Setup
12.6.1 Set Patient Type
Patient type includes Adu, Ped, and Neo. Please select an appropriate type for the monitored patient, and it should
be consistent with the type set in [Patient Type] under [Patient Management].
1) Select the NIBP parameter area to enter [NIBP] menu.
2) Select [Setup] tab.
3) Set [Patient Type]: [Adu], [Ped] or [Neo].
12.6.2 Set NIBP Alarm
1) Select the NIBP parameter area to enter [NIBP] menu.
2) Select [Alarm] tab.
3) Set the alarm as required.
12.6.3 Set Initial Pressure
1) Select NIBP parameter area to enter [NIBP] menu.
2) Set [Initial Pressure]: select a proper initial pressure for cuff as needed.
12.6.4 NIBP End Tone
The monitor will give a single tone prompt when the NIBP measurement is completed. [NIBP End Tone] defaults to
[Off], but you can turn it on by the following steps:
1) Select NIBP parameter area to enter [NIBP] menu.
2) Select [Setup] tab.
3) Turn on [NIBP End Tone].
To Next Page
