21-1
Chapter 21 Print
21.1 Printer
The Monitor can output patient reports through a USB cable connected to a printer or networked printer.
Currently, the monitor supports the following types of printers that comply with IEC 60950-1 and relevant safety
standards.
Specification of reports printed by the printer:
Paper: A4
Resolution: 300dpi
Single/double-sided: Supports both single and double-sided printing, if supported by the printer.
For instructions on the printer, please see the accompanying documents with the printer. If you have any
question about your printer, please feel free to contact us.
21.2 Set the Printer Type
1) Click [Main Menu] hot key → [System] → [Maintenance], enter the maintenance password and click the Enter
key;
2) Click [Print] tab;
3) Set [Printer Type] to:
[USB]: to print reports through USB cable connected printer directly; or
[NET]: to print reports after setting the printer properties (refer to “
Section 21.3 Set the Networked
Printer”
).
21.3 Set the Networked Printer
The reports stored on the Monitor can be printed through a networked printer. Follow the steps below to set the
networked printer:
1) Click [Main Menu] hot key → [System] → [Maintenance], enter the maintenance password and click the Enter
key;
2) Click [Print] tab;
3) Set the [Printer IP Address]: click the " " button on the far right of the printer IP address input box; on the
pop-up page, enter the IP of any printer in the LAN as the printer of the Monitor;
To Next Page
