TEMP Monitoring
13-3
3) Set [ΔT] to On.
13.5.3 Set Temp Sensor Type
1) Select [Main Menu] → [System] → [Maintenance], enter the maintenance password and click the Enter key.
2) Select [Other] tab.
3) Set [Temp Sensor Type] based on the type of Temp sensor used.
13.5.4 Turn Off Dual Temp Display
[Dual Temp Display] defaults to [On]; to turn off T2 channel measurement, you can turn off [Dual Temp Display] in
the following way:
1) Select [Main Menu] → [System] → [Maintenance], enter the maintenance password and click the Enter key.
2) Select [Other] tab.
Turn off [Dual Temp Display].
To Next Page
