Maintenance
24-4
No dirt on the outer shell of the device; no crack or damage on the panel or screen.
The power cord is not worn out and has a good insulation performance.
The connector, plug and cable are not damaged or entangled.
Cables are well connected with the device and modules.
24.5.2 Startup inspection
The monitor will perform a self-inspection after startup. The inspection items are listed as follows:
The monitor can boot normally
The alarm system works normally
The screen displays normally
24.5.3 Recorder test
1) Enable a record print task to print the waveform and report.
2) Check whether the paper is fed normally
3) Check whether the waveform and texts are displayed clearly and completely.
24.5.4 Network printer test
1) Start the printer to print the real-time waveform and report.
2) Check if the printer is connected well and working properly
3) Check whether the waveform and texts are printed are clearly and completely.
24.5.5 Battery inspection
Refer to
"Section 22.4 Optimize and Check Battery Performance"
.
24.5.6 Monitor disposal
When the monitor reaches the end of its service life, dispose of it and its accessories according to local laws and
regulations.
To Next Page
