Basic Operations
4-4
You can exit Privacy Mode:
by selecting [Exit Privacy Mode] on the screen; or
by disconnecting from the CMS; or
when the battery level is too low.
4.2.4 Standby Mode
If patient monitoring is not needed for the time being, but you don't want to shut down the device, Standby Mode
can be used.
Here are the steps for entering Standby Mode:
1) Select the [Standby] or [Main Menu] hot key → select [Standby] from the [Patient Management] column.
2) Set the patient location in standby.
3) Select OK.
Performance of the device in standby mode:
Stops all parameter measurements.
All alarm messages (except Low Battery) and prompt messages are shielded.
Exit Standby Mode:
Select [Resume Monitoring] to exit standby mode and restore monitoring for the current patient.
Select [Discharge Patient] to discharge the current patient from the monitor.
4.2.5 Demo
Here are the steps for entering Demo Mode:
Select [Main Menu]; select [Demo] from the [System] column; input the password to enter Demo Mode.
Demo waveforms are simulated waveforms set by the manufacturer only for the purpose of
demonstrating device performance and aids in user training. In actual clinical use, it is forbidden to use
the demo function because medical workers may mistake the demo data for waveforms and parameters
of the patient being monitored, which will affect patient monitoring and delay diagnosis and treatment.
To Next Page
