Comen N10 - General Settings; Enter Parameter Setup Window; Switch Screen; Spo 2 Screen

Basic Operations
4-5
4.3 General Settings
4.3.1 Enter Parameter Setup Window
Each parameter shown on the screen can be set. The user can enter the Setup window in the following ways:
 Select the waveform area or parameter area corresponding to a parameter.
 Select the [Parameter Setup] hot key in the main screen; then select the corresponding parameter.
 Select the [Main Menu] hot key; select [Setup] from the [Param.] column; then select the corresponding
parameter.
NOTE
 Usually, the description of entering parameter settings in this manual uses the first method.
4.3.2 Switch Screen
Normal screen, which is the so-called standard screen, is the most commonly used monitoring screen. The monitor
enters the normal screen upon startup. You can also choose the screen as needed according to the following steps:
1) You can enter the [Choose Screen] page in either of the following ways:
 Select the [Screen Setup] hot key → select [Choose Screen].
 Select the [Main Menu] hot key → select [Choose Screen] from the [Display] column.
2) Choose the screen type as required.
You can also directly horizontally swipe on the screen using two fingers to switch the screen.
4.3.2.1 SpO
2
Screen
For neonatal patient monitoring, if you are more concerned with the patient’s SpO
2
and pulse rate, you can choose
SpO
2
screen. This screen only displays the numerical parameter of SpO
2
and PR, body temperature and the NIBP
measurement.
NOTE
 The SpO
2
screen is only for neonatal patients.