Comen N10 - Change the Time Step of Tabular Trends; Print the Tabular Trends Report; Graphic Trends; Go to the Graphic Trends Page

Clinical Assistant Assessment (CAA)
17-3
17.4.3 Change the Time Step of Tabular Trends
Time step refers to the time interval of the trend data displayed on the screen. You can select a larger time step for
neonatal patients as their clinical conditions may change rapidly, and select a smaller time step for adult patients
as their clinical conditions will change relatively slowly.
Follow the steps below to set the time step:
1) On the [Tabular Trends] page, set [Time Step] to:
 [5s] or [30s]: to observe the parameter trends of the last 4h at a 5s or 30s interval;
 [1min], [5min], [15min], [30min], [1h], [2h] or [3h]: to observe the parameter trends of the last 120h at the
selected interval; or
 [NIBP] or [C.O.]: to display the values of such parameters at the time of measurement.
17.4.4 Print the Tabular Trends Report
1) On the Tabular Trends page, click " " to go to the [Print Setup] menu.
2) Set the Tabular Trends Report. See “ Section 21.6.3 Set the Tabular Trends Report” .
3) Click " " to print the tabular trends report.
NOTE
 In the tabular trends report, if any parameter name is preceded by a "+" mark, that means this is the
trend data of an external device.
4) .
17.5 Graphic Trends
Graphic trends are a set of patient data displayed graphically over time.
17.5.1 Go to the Graphic Trends Page
Follow either path described below to go to the Graphic Trends page:
 Click [Review] hot key → [Graphic Trends] tab; or
 Click [Main Menu] hot key → [Review] → [Graphic Trends].