Comen N10 - Set Default Patient Category; Change Department; Select Default Configuration

Manage Configuration
6-16
NOTE
 The monitor will load the factory default settings when changing Department, admitting patient and
changing patient type.
6.2 Set Default Patient Category
You can set the patient type when admitting a patient as follows:
1) Click [Main Menu] hot key → [Configuration] → [Manage], enter the configuration password and click the
Enter key.
2) Select the drop-down list on the right of [Default Patient Category] to set the patient type when admitting a
patient.
6.3 Change Department
1) Click [Main Menu] hot key → [Configuration] → [Manage], enter the configuration password and click the
Enter key
2) Click the [Change Department] button.
3) Select the appropriate department.
4) Click [OK].
6.4 Select Default Configuration
The Default Configuration is the one that is automatically loaded when:
 Admitting a patient
 Discharging a patient
 Changing patient type
 Changing department
The Default Configuration can be chosen from the latest settings, defaults settings and user settings.
Select the Default Configuration as follows:
1) Click the [Main Menu] hot key → [Configuration] → [Manage], enter the configuration password and click the
Enter key
2) Click the [Select Default Config] button.
3) Select [Load the Latest Config] or [Load Specified Config]
 Select [Load the Latest Config]: the monitor will load the latest configuration when admitting a patient.
 Select [Load the Specified Config]: the monitor will load the specified configuration when admitting a
patient. The monitor will load Adu, Ped. or Neo. configuration according to the patient type. The factory