Comen N10 - Auto Scoring; EWS Setup; Select a Score System; Set the Scoring Interval

Clinical Assistant Assessment (CAA)
18-5
patients with hypercapnic respiratory failure).
3) Measure the values of other parameters or enter them manually.
4) Click [Calculate] to obtain the score results.
NOTE
 The decision to use Scale 2 of the SpO
2
Scale should be made by a competent clinical decision maker and
should be recorded in the patient’s clinical notes.
 Please click [Reset] to clear the last score results before each scoring.
 The keyboard symbol to the right of the parameter value indicates that such value was entered manually.
 To calculate the scores, make sure the values of all parameters involved in the calculation are valid.
18.2.3 Auto Scoring
1) On the EWS screen, click [MEWS] tab → [Setup].
2) In the [Auto Score] area, check an option as required:
 [Interval Mode]: the Monitor will automatically calculate scores at the selected interval.
 [NIBP]: the Monitor will automatically calculate scores at the end of each NIBP measurement.
 [Alarm]: the Monitor will automatically calculate scores when a physiological alarm occurs to any
parameter involved in scoring.
18.2.4 EWS Setup
18.2.4.1 Select a Score System
The Monitor provides a default score system. You can also follow the steps below to select other score systems as
required:
1) On the EWS screen, click [MEWS] tab → [Setup].
2) Set the [Score].
18.2.4.2 Set the Scoring Interval
1) On the EWS screen, click [MEWS] tab → [Setup].
2) Set the Measure Interval:
 If [Interval Mode] in the [Auto Score] area is not checked: set the countdown time of manual scoring.
 If [Interval Mode] in the [Auto Score] area is checked: set the measurement interval of automatic scoring.