Comen N10 - Set Items Displayed in the Patient Management Menu; Set Monitor Information; Set the Device Location

Patient Management
5-14
5.3.3 Set Items Displayed in the Patient Management Menu
You can set whether or not to display and edit the patient's room No., middle name, race, age and other information
in the following way:
1) Select the [Main Menu] hot key → select [Maintenance] from the [System] column → input the maintenance
password → press the Enter key.
2) Select the [Patient Management] tab → select the [Field] tab.
3) Select the patient information to be displayed and edited in the [Patient Management] menu.
4) If necessary, select the Custom Patient Information Area and input the name of this area.
5.3.4 Set Monitor Information
You can set a name for the monitor in the following way:
1) Select the [Main Menu] hot key → select [Maintenance] from the [System] column → input the maintenance
password → press the Enter key.
2) Select the [Device Location] tab.
3) Set [Monitor Name], [Hospital] and [Department].
5.3.5 Set the Device Location
If the location of the monitor is fixed, or it is not needed to move the monitor frequently, you can set [Location] to
[Fixed]. Here are the steps for setting device location:
1) Select the [Main Menu] hot key → select [Maintenance] from the [System] column → input the maintenance
password → press the Enter key.
2) Select the [Device Location] tab.
3) Set [Location].
 When [Fixed] is selected, the [Patient Management] menu can only display the patient's room No. or bed
No., and you cannot modify the room No. or bed No..
 When [Unfixed] is selected, you can enter the [Patient Management] menu to modify the patient's room
No. and bed No..
4) Input [Room No.] and [Bed No.].
NOTE
 If [Location] is set to [Unfixed], Room No. and Bed No. will be cleared each time after patient discharge;
you need to re-input Room No. and Bed No..