Alarms
7-11
7.15.2 Technical Alarm Reset
When the technical alarm is reset,
For fully clearable technical alarm conditions the alarm audio will be cancelled. The monitor will give no alarm
indicaitons of the cleared technical alarms.
Clearable alarm conditions will be changed to prompt messages.
For not fully clearable technical alarm conditions the alarm audio will be cancelled, while a symbol will
appear before the alarm message, indicating that the alarm has been acknowledged.
7.15.3 Set Alarm Light Status after Alarm Reset
The alarm light defaults to [On]. It can by turned off as follows:
1) Click [Main Menu] hot key → [System] → [Maintenance], enter the maintenance password and click the Enter
key.
2) Click [Alarm] tab → [Pause/Reset] tab.
3) Set [Alarm Light]
[On When Reset]: The light of the existing alarm will flash but the sound of it will be muted after alarm
reset.
[Off When Reset]: The light and sound of the existing alarm will both be turned off after alarm reset.
7.16 Alarms at Remote View
7.16.1 Set Remote View Reminder
1) Click [Main Menu] hot key → [System] → [Maintenance], enter the maintenance password and click the Enter
key.
2) Select [Alarm] tab → [Network] tab.
3) Set [Remote View Reminder].
[Light + Sound]: the alarm light and alarm sound will be kept on when alarming.
[Only Light]: Only the alarm light will be kept on when alarming.
7.16.2 Set Remote View Priority
1) Click [Main Menu] hot key → [System] → [Maintenance], enter the maintenance password and click the Enter
key.
2) Select [Alarm] tab → [Network] tab.
To Next Page
