Comen N10 - Quick Admit; Normal Admit; Patient Information; Enter Patient Management Menu

Patient Management
5-13
5.2.1 Quick Admit
When the user does not have enough time to get patient info, the Quick Admit mode can be used. Later, the user
must complete the other info of the patient.
Here are the steps:
1) After patient discharge, select [Monitor] to quickly admit a patient.
2) After admitting the patient please input the patient information as fast as possible. See “ Section 5.3.2 Edit
Patient Information ” for detailed instructions.
5.2.2 Normal Admit
After patient discharge, select [Patient Management] → then input the information of the new patient. See
“ Section 5.3.2 Edit Patient Information ”.
5.3 Patient Information
5.3.1 Enter Patient Management Menu
You can enter the [Patient Management] menu in any of the following ways:
 Select the Patient Information Area at the upper left corner of the screen.
 Select the [Patient Information] hot key.
 Select [Main Menu] → select [Patient Information] from the [Patient Management] column.
5.3.2 Edit Patient Information
After a patient is admitted, if the patient information is incomplete or needs to change, you can edit the patient
information according to the following steps:
Enter the [Patient Management] menu, and edit the patient information as required.
If your monitor is connected with a barcode scanner, you can input the medical record number or registration
number by scanning the barcode.
NOTE
 When the patient type is changed, the monitor will load the default configuration of that patient type.