Comen N10 - Page 27

307 pages

Save Page as PDF

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

Safety

1-5

Warning: Only use the cable provided by Comen. The defibrillation protection relied on

accessories.

This Side Up

Stacking Layer Limit

Fragile

Keep dry

Does not contain DEHP

Latex free

Do not re-use

Use-by date

Do not use if package is damaged

and consult instructions for use

Do not re-sterilize

Table of Contents

After-Sales Service2
- Table of Contents5
- Blank Page22
Chapter 1 Safety23
- Safety Information23
- Contraindications25
- Symbols26
Chapter 2 Overview28
- Product Introduction28
- Monitor Appearance30
- On-Screen Display (OSD)34
Chapter 3 Installation and Preparation39
- Installation39
  - Unpacking and Checking39
  - Environmental Requirements39
- Device Preparation40
- Connection of Device Components41
  - Connect the Sensor41
- Startup and Shutdown42
  - Startup42
  - Shutdown42
Chapter 4 Basic Operations44
- Operation and Browsing44
- Working Modes45
- General Settings48
- Waveform Freezing51
- Use of Timers52
Chapter 5 Patient Management55
- Discharging a Patient55
- Admitting a Patient55
  - Quick Admit56
  - Normal Admit56
- Patient Information56
Chapter 6 Manage Configurations58
- Set Default Patient Category59
- Change Department59
- Select Default Configuration59
- Save Current Settings60
- Delete Configuration60
- Export Configurations60
- Import Configuration60
- Load Configurations61
- Manage Configuration Password61
Chapter 7 Alarms62
- Safety Information62
- Alarm Types63
- Alarm Priority63
- Alarm Signals63
  - Alarm Indicator Light63
  - Sound Alarm64
  - Alarm Message64
  - Alarm Parameter Forms64
  - Alarm Status Icon64
- View Physiological Alarm Conditions65
- View Technical Alarm Conditions65
- Set Alarm Limits65
  - Manual Adjust Alarm Limit65
  - Set Auto Alarm Limits65
- Set Alarm Volume66
  - Set Minimum Alarm Volume66
  - Set Alarm Reminder67
  - Set the Function of Alarm Volume Enhancing67
- Alarm Paused/Alarm Audio Pause67
  - Alarm Paused Categories67
  - Alarm Pause68
  - Set Alarm Pause Time68
  - Delay Alarm Pause Time68
  - Alarms All off69
  - Alarm Audio Pause69
  - Set Alarm Audio Pause Time69
  - Delay Alarm Audio Pause Time69
  - Alarm Audio off70
- Set Spo Desat Alarm (Not for Rainbow Spo )70
- Set the Switch Status of Apnea Alarm70
- Set the Switch Status of CMS Disconnection Alarm70
- Set the Switch Status of CMS Alarm System Control71
- Set Alarm Delay Time71
- Alarm Reset71
  - Physiological Alarm Reset71
  - Technical Alarm Reset72
  - Set Alarm Light Status after Alarm Reset72
- Alarms at Remote View72
  - Set Remote View Reminder72
  - Set Remote View Priority72
  - Remote View Reset73
  - Alarm Reset by Remote View73
- Set Nurse Call73
  - Nurse Call Setup73
- Cardiopulmonary Bypass (CPB) Mode74
  - Enter CPB Mode74
  - Exit CPB Mode74
- Intubation Mode75
  - Enter Intubation Mode75
  - Set Intubation Mode Time75
  - Exit Intubation Mode75
- Alarm Auto Print75
- Restore Alarm Defaults76
- Alarm System Self-Test76
Chapter 8 ECG Monitoring77
- Safety Information77
- ECG Display78
- Monitor Setup79
- ECG Setup84
- Arrhythmia Analysis88
- Heart Rate Variability92
- ST Segment Analysis96
- Qt/Qtc Monitoring102
- ECG Relearn105
  - Start ECG Relearn Automatically105
  - Start ECG Relearn Manually105
- Defibrillation Synchronization105
Chapter 9 12-Lead Resting ECG Analysis107
- About 12-Lead Resting ECG Analysis107
- Enter 12-Lead107
- Start 12-Lead Resting ECG Analysis107
- Glasgow 12-Lead ECG Analysis Setup107
- Save 12-Lead Report109
- Print 12-Lead Report109
- Exit 12-Lead Analysis Window109
Chapter 10 Resp Monitoring110
- Resp(Respiration) Measurement110
- Safety Information110
- Resp Display111
- Placement of Electrodes111
  - Optimization of Lead Position111
- Resp Setup112
- Enter Intubation Mode114
Chapter 11 Spo 2 Monitoring115
- Overview115
  - Identification of Spo Type115
- Safety Information116
  - Masimo Spo2 Specific Information119
- Measurement Restrictions120
- Spo 2 Display120
- Low Perfusion Accuracy Test121
- Monitoring Steps121
  - Comen Spo Measurement Steps121
  - Masimo Spo 2 & Nellcor Spo 2 Measurement Steps121
- Placement of the Spo 2 Sensor122
- Spo Setup123
- PR Setup127
- Masimo Information128
- Nellcor Information128
Chapter 12 NIBP Monitoring129
- Overview129
- Safety Information129
- Measurement Restrictions130
- NIBP Display131
- Display NIBP List132
- NIBP Setup132
- NIBP Measurement133
- Venipuncture136
- NIBP Analysis137
Chapter 13 TEMP Monitoring139
- TEMP Overview139
- Set Temperature Display Area139
- Temperature Display139
- Temperature Measurement139
- Temperature Setup140
Chapter 14 IBP Monitoring142
- Overview142
- Safety Information142
- Monitoring Steps143
- IBP Display144
- IBP Setup145
- PAWP Measurement148
Chapter 15 CO 2 Monitoring153
- Overview153
  - Indication on CO Module153
- Safety Information154
- Adverse Effects on Performance（Masimo154
- CO Display155
- CO Measurement156
- Zeroing the CO Sensor161
- CO Setup162
- Discharging Waste Gases166
- Information on MASIMO Mainstream & Sidestream Gas Modules166
Chapter 16 C.O. Monitoring173
- Overview173
- Measurement Limitations174
- Display174
- Setup175
- Cardiac Output Measurement176
Chapter 17 Data Review180
- Overview180
- Review Screen180
  - Go to the Review Screen180
  - Structure of Review Screen180
- Icons on the Review Screen181
- Tabular Trends181
- Graphic Trends182
- Events Review183
- Full-Disclosure Waveforms185
- 12-Lead Report Review187
- Minitrends189
- Oxycrg190
  - Select Parameters and Scale190
  - Set the Window Time190
- Close Unnecessary Review Items190
Chapter 18 Clinical Assistant Assessment (CAA)191
- Sepsisguide191
- Early Warning Score (EWS)193
- Glasgow Coma Scale (GCS)196
- ECG 24H Summary197
- Pacer View198
- CCHD (Critical Congenital Heart Disease) Screening200
Chapter 19 Calculation205
- Overview205
- Safety Precautions205
- Drug Calculation205
- Hemodynamic Calculation207
- Ventilation Calculation210
  - Input Parameters210
  - Output Parameters211
- Renal Function Calculation211
  - Input Parameters211
  - Output Parameters212
Chapter 20 Record213
- Description of Recorder213
- Start Recording213
  - Start Recording Manually213
  - Start Recording Automatically213
- Stop Recording214
  - Stop Recording Manually214
  - Stop Recording Automatically214
- Set the Recorder214
- Set to Automatic Recording214
- Clear Record Task215
- Load Recording Paper215
- Clear Jammed Paper215
- Recorder Cleaning215
Chapter 21 Print217
- Printer217
- Set the Printer Type217
- Set the Networked Printer217
- Manual Printing218
  - Start Printing on the Current Page218
  - Print Normal Reports218
- Automatic Printing218
- Set the Printed Report219
Chapter 22 Battery221
- Overview221
- Installing the Battery222
- View Battery Information222
- Optimize and Check Battery Performance222
  - Optimize Battery Performance222
  - Check Battery Performance222
- Battery Recycling223
Chapter 23 Cleaning and Disinfection225
- Overview225
- Cleaning of the Monitor, Plug-In Modules226
- Disinfection of the Monitor, Plug-In Modules227
- Cleaning and Disinfection of Accessories227
  - Cleaning and Disinfection of NIBP Cuffs227
  - Cleaning and Disinfection of Other Accessories228
    - Cleaning228
    - Disinfection228
- Sterilization229
Chapter 24 Maintenance230
- Maintenance Checks230
- Maintenance Plan231
- Service Life of Reusable Accessories232
- Version Information232
- Testing Methods and Steps232
- NIBP Leakage Test234
- NIBP Verify234
- ECG Calibration234
- IBP Calibration234
Chapter 25 Other Functions235
- Network Connection235
- Central Monitoring System Connection236
- Connection to the Hospital's Information System by HL7 Protocol237
- Remote View237
  - Enter Remote View Window237
Appendix I Accessories238
Appendix II Product Specifications247
Appendix IV Default Configuration Information283
Appendix V EMC294
Appendix VI Glasgow 12-Lead ECG Analysis304
- VI.1 Wave Measurement304
- VI.2 ST Segment and Amplitude Measurement305
- VI.3 Interval Measurements306
- VI.4 Stability of Measurements against Noise306
- VI.5 Analyzing Electrocardiograph Intended Use307

Related product manuals

Preview: Comen CM300