The Mix Output Menu
Spark
21-7
Assigning a default space
You can also assign DMX output address by entering a default space. The Default Space
option assigns the selected default space to all spots per selected connector; therefore you
can only use this if all of the spots output from the connector have the same DMX offset.
Keypresses Results/Comments
1. Press F1 DMX Address
2. Press F1 Default Space
You are prompted to enter the default
output length.
3. Select the number of DMX
channels that will be allocated
to each spot.
4. Select the connector
assignment.
Each spot is assigned a DMX output
address according to the default offset.
Or
Keypresses Results/Comments
1. Press F1 DMX Address
2. Press F2 Select Spot
3. Enter the spot numbers on the
keypad.
4. Select the connector. Spark prompts for a beginning address.
5. Enter the first DMX address
that you will use for spots.
6. Press F1 Default Space
You are prompted to enter the default
output length.
7. Select the number of DMX
channels that will be allocated
to each spot.
8. Press F1 Store
The DMX addresses appear under the spot
numbers.
To Next Page
Loading...
Need help?
General