Spot Parameters
Spark
6-8
Turning on the dimmer parameter
There are a few ways to turn on the dimmer of the selected spots:
• Press [FULL].
• Press [ON].
• Use the dimmer wheel.
• Press [@] and assign an intensity level using the numeric keypad.
• Pressing [ZERO] forces the dimmer to 0%.
Assigning values for continuous steps
Continuous parameters wheel up from zr to Full. Continuous parameter values are
displayed as a number from zr - FL.
Assigning parameter values using the numeric keypad
Keypresses Results/Comments
1. Select spots. The controller SK display shows the
parameter selections. If you do not see the
parameter display, press [PARAM].
2. Press the SK for the parameter
selection.
The parameter name is shown on a red field
on the Stage Display and the assigned
parameter wheel jumps to the correct wheel
bank. The bank number and parameter
name are displayed in the LED wheel
window.
3. Enter the parameter value on
the numeric keypad.
Examples of value assignments: 5 (is 50%),
7.5 (is 75%).
If the system is set to USA system (see
Chapter 19 System Configuration) enter a
2-digit number. Examples: 50 (for 50%) 75
(for 75%).
Assigning a value using the wheel
Example: Assign 65% to a continuous parameter
Keypresses Results/Comments
1. Select spots. The controller SK display shows the
parameter selections. If you do not see the
parameter display, press [PARAM].
2. If necessary press [WHEEL +]
or [WHEEL -] until the
parameter is displayed in the
LED window.
3. Turn the parameter wheel until
the value reaches
65
.
The parameter name is shown on a red field
on the Stage Display