Compulite Spark User Manual

Spot Parameters
Spark
6-11
Assigning a mixed step value using the wheels
Example: assign step 2 at 30% to Golden Scan’s color wheel parameter (p2).
Keypresses Results/Comments
1. Select spots. The controller SK display shows the
parameter selections. If you do not see the
parameter display, press [PARAM].
2. Press the SK for the parameter
selection.
3. Press [STEP UP] or [STEP
DOWN] to reach step 2
4. Move the wheel until 2.3 is
reached.
The parameter value for p2 shows
2.3
.
Or
Keypresses Results/Comments
1. Select spots. The controller SK display shows the
parameter selections. If you do not see the
parameter display, press [PARAM].
2. Press the SK for parameter
selection.
3. Press and hold {SHIFT]
The SK display shows the corresponding
steps.
4. Press SK 2
5. Move the wheel until 2.3 is
reached.
The parameter value for p2 shows
2.3
.
Parameter mode assignments for Cyberlight and
Intellabeam
Certain parameters of Intellabeam and Cyberlight have multiple operation modes (such as
a color wheel which can have a half color, rotation, etc.). Modes are represented by an
additional icon displayed after the parameter value. Access to the parameter modes is
through SKs after parameter selection.
These parameters are:
• Static gobo (p6) - Cyberlight and Intellabeam.
• Shutter (p 8) - Cyberlight and Intellabeam.
• Rotating gobo (p13) - Cyberlight only.
• Color wheel - (p 14 for Cyberlight; p2 for Intellabeam)
When you select one of these special parameters on the SKs, the operation modes are
displayed on the on the Controller display in PARAM mode. Press the operation mode that
you want and continue as usual.

Compulite Spark Specifications

General

Brand	Compulite
Model	Spark
Category	Controller
Language	English