Danfoss VLT series Programming Guide

Attribute Value
Access Read/write
Data type UNSIGNED32
PDO mapping Optional
Value range
1 to 2
32
–1
Default value 1
Sub-index 0x02
LCP parameter number 55-41
Description Divisor
Access Read/write
Data type UNSIGNED32
PDO mapping Optional
Value range
1 to 2
32
–1
Default value 1
Table 7.46 0x6097: Acceleration Factor
7.5 Commonly Used Objects
7.5.1 Parameter 52-00: Modes of Operation (0x6060)
This object indicates the requested operation mode and only shows the value of the requested operation mode. The actual
mode of operation of the servo drive is reected in object 0x6061 (see chapter 7.5.2 Parameter 52-01: Modes of Operation
Display (0x6061)). A value of 0 does not change the currently active mode of operation.
Attribute Value
Index 0x6060
LCP parameter number 52-00
Name Modes of operation
Object code Var
Data type INTEGER8
Sub-index 0x00
Access Read/write
PDO mapping Optional
Value range See Table 7.48.
Default value 0
Table 7.47 0x6060: Modes of Operation
This object provides the output value of the trajectory generator. The value is given in
user-dened velocity units.
Servo Drive Parameter Descr... Programming Guide
MG36D102 Danfoss A/S © 01/2017 All rights reserved. 247
7 7

Danfoss VLT series Specifications

General

Series	VLT
Category	DC Drives
Output Voltage	0-100% of input voltage
Protection Features	Overvoltage, Undervoltage, Overcurrent, Overtemperature, Short Circuit, Ground Fault
Communication Interfaces	Profibus, CANopen
Enclosure Rating	IP20, IP21, IP55, IP66
Cooling Method	Forced Air Cooling, Convection Cooling
Control Mode	Sensorless Vector, Closed Loop Vector
Ambient Temperature	-10°C to +50°C (14°F to 122°F)