Danfoss VLT series Programming Guide

Attribute Value
Data type INTEGER32
Sub-index 0x00
Description Value of highest sub-index
Access Read only
PDO mapping No
Default value 0x02
Sub-index 0x01
LCP parameter number –
Description First position of touch probe 1
Access Read/write
Data type INTEGER32
PDO mapping Optional
Value range INTEGER32
Default value –
Sub-index 0x02
LCP parameter number –
Description First position of touch probe 2
Access Read/write
Data type INTEGER32
PDO mapping Optional
Value range INTEGER32
Default value –
Table 7.193 0x3853: First Position
7.18.9 Parameter: Last Position (0x3854)
This object denes the end position of the window. The value is given in user-dened position units.
Attribute Value
Index 0x3854
Name Last position
Object code Array
Data type INTEGER32
Sub-index 0x00
Description Value of highest sub-index
Access Read only
PDO mapping No
Default value 0x02
Sub-index 0x01
LCP parameter number –
Description Last position of touch probe 1
Access Read/write
Data type INTEGER32
PDO mapping Optional
Value range INTEGER32
Default value –
Sub-index 0x02
LCP parameter number –
Servo Drive Parameter Descr... Programming Guide
MG36D102 Danfoss A/S © 01/2017 All rights reserved. 323
7 7

Danfoss VLT series Specifications

General

Series	VLT
Category	DC Drives
Output Voltage	0-100% of input voltage
Protection Features	Overvoltage, Undervoltage, Overcurrent, Overtemperature, Short Circuit, Ground Fault
Communication Interfaces	Profibus, CANopen
Enclosure Rating	IP20, IP21, IP55, IP66
Cooling Method	Forced Air Cooling, Convection Cooling
Control Mode	Sensorless Vector, Closed Loop Vector
Ambient Temperature	-10°C to +50°C (14°F to 122°F)