Danfoss VLT series Programming Guide

Attribute Value
Default value –
Table 7.190 0x60BD: Touch Probe 2 Negative Edge
7.18.7 Parameters 51-50 and 51-60: Touch Probe Source (0x60D0)
This object provides the source of the touch probe functions.
Value Denition
0 Reserved.
+1 Touch probe 1 input.
+2 Touch probe 2 input.
Table 7.191 Value Denition for Touch Probe Source
Attribute Value
Index 0x60D0
Name Touch probe source
Object code Array
Data type INTEGER16
Sub-index 0x00
Description Value of highest sub-index
Access Read only
PDO mapping No
Default value 0x02
Sub-index 0x01
LCP parameter number 51-50
Description Touch probe 1 source
Access Read only
Data type INTEGER16
PDO mapping No
Value range See Table 7.52.
Default value +2
Sub-index 0x02
LCP parameter number 51-60
Description Touch probe 2 source
Access Read only
Data type INTEGER16
PDO mapping No
Value range See Table 7.52.
Default value +1
Table 7.192 0x60D0: Touch Probe Source
7.18.8 Parameter: First Position (0x3853)
This object denes the start position of the window. The value is given in user-dened position units.
Attribute Value
Index 0x3853
Name First position
Object code Array
Servo Drive Parameter Descr...
VLT
®
Integrated Servo Drive ISD
®
510 System
322 Danfoss A/S © 01/2017 All rights reserved. MG36D102
77

Danfoss VLT series Specifications

General

Series	VLT
Category	DC Drives
Output Voltage	0-100% of input voltage
Protection Features	Overvoltage, Undervoltage, Overcurrent, Overtemperature, Short Circuit, Ground Fault
Communication Interfaces	Profibus, CANopen
Enclosure Rating	IP20, IP21, IP55, IP66
Cooling Method	Forced Air Cooling, Convection Cooling
Control Mode	Sensorless Vector, Closed Loop Vector
Ambient Temperature	-10°C to +50°C (14°F to 122°F)