Danfoss VLT series

Attribute Value
Value range FLOAT
Default value 0.01
Sub-index 0x03
LCP parameter number 51-22
Description Speed controller inertia
Access Read only
Data type FLOAT
PDO mapping Optional
Value range FLOAT
Default value Dependent on motor type and brake conguration.
Sub-index 0x04
LCP parameter number 51-23
Description Speed controller dierential
Access Read only
Data type FLOAT
PDO mapping Optional
Value range FLOAT
Default value 0
Sub-index 0x05
LCP parameter number 51-24
Description Center frequency
Access Read only
Data type FLOAT
PDO mapping Optional
Value range FLOAT
Default value 0
Sub-index 0x06
LCP parameter number 51-25
Description Bandwidth
Access Read only
Data type FLOAT
PDO mapping Optional
Value range FLOAT
Default value 0
Table 7.69 0x2014: Speed Controller Parameters 2
Servo Drive Parameter Descr... Programming Guide
MG36D102 Danfoss A/S © 01/2017 All rights reserved. 259
7 7