Danfoss VLT series Programming Guide

Attribute Value
Access Const
Data type UNSIGNED8
PDO mapping No
Default value 0x04
Sub-index 0x01
LCP Parameter number 16-34
Description Temperature module
Access Read only
Data type INTEGER16
PDO mapping Optional
Value range INTEGER16
Default value –
Sub-index 0x02
LCP Parameter number 16-39
Description Temperature PCB 1
Access Read only
Data type INTEGER16
PDO mapping Optional
Value range INTEGER16
Default value –
Sub-index 0x03
LCP Parameter number 16-31
Description Temperature PCB 2
Access Read only
Data type INTEGER16
PDO mapping Optional
Value range INTEGER16
Default value –
Sub-index 0x04
LCP Parameter number 16-19
Description Temperature wire motor
Access Read only
Data type INTEGER16
PDO mapping Optional
Value range INTEGER16
Default value –
Table 7.266 0x2000: Temperature
Servo Drive Parameter Descr... Programming Guide
MG36D102 Danfoss A/S © 01/2017 All rights reserved. 357
7 7

Danfoss VLT series Specifications

General

Series	VLT
Category	DC Drives
Output Voltage	0-100% of input voltage
Protection Features	Overvoltage, Undervoltage, Overcurrent, Overtemperature, Short Circuit, Ground Fault
Communication Interfaces	Profibus, CANopen
Enclosure Rating	IP20, IP21, IP55, IP66
Cooling Method	Forced Air Cooling, Convection Cooling
Control Mode	Sensorless Vector, Closed Loop Vector
Ambient Temperature	-10°C to +50°C (14°F to 122°F)