Danfoss VLT series Programming Guide

All numerical values accept a point as decimal separator.
The scientic representation of numbers is also allowed,
where a small “e” or a capital “E” may be used. Any other
characters inside the value cannot be used and lead to an
error.
Examples of allowed values:
•
532.4
•
+532.4
•
–532
•
–9.398846E-6
•
–9.398846e-6
•
9.398846e+3
•
–0.000305
Appendix
VLT
®
Integrated Servo Drive ISD
®
510 System
382 Danfoss A/S © 01/2017 All rights reserved. MG36D102
1010

Danfoss VLT series Specifications

General

Series	VLT
Category	DC Drives
Output Voltage	0-100% of input voltage
Protection Features	Overvoltage, Undervoltage, Overcurrent, Overtemperature, Short Circuit, Ground Fault
Communication Interfaces	Profibus, CANopen
Enclosure Rating	IP20, IP21, IP55, IP66
Cooling Method	Forced Air Cooling, Convection Cooling
Control Mode	Sensorless Vector, Closed Loop Vector
Ambient Temperature	-10°C to +50°C (14°F to 122°F)