14
Introduction
Operational safety
Information about the laser used
This laser product is classified as a class 1
laser product in accordance with the
national/international standards DIN
EN 60825-1 : 2003-10 and DHHS Rules
21 CFR Subchapter J to the date of
manufacture.
The laser beam in this class 1 laser product
is so weak that it poses no threat in any
situation, or this product is designed that
the laser beam is limited to the inside of the
device. A laser encased in this device can,
however, still be powerful enough to qualify
as a higher class of laser. For this reason
the protective case should not be opened at
any time (loss of warranty).
Technical data for the laser equipment
inside the device:
Output power from laser beam: 0.68 mW
(DVD) / 0.85 mW (CD)
Wave length of laser beam: 665 nm (DVD)
/ 795 nm (CD)
The laser diode is not pulsed during
operation.
Information about the operating
temperature range
Temperature range in which the Driver
Information System provides full
functionality: -4° F - +149° F
(-20° C - +65° C).
Temperature range in which the Driver
Information System can be stored and
then operate normally in the above-
mentioned range: -40° F - +176° F
(-40° C - +80° C)
If the temperature is too low or to high, the
Driver Information System may not work.
This is not a product malfunction. So, don’t
be alarmed and use the system after a
while.
Intended purpose
Please keep the following information in
mind when using the Driver Information
System:
The safety instructions in this manual
The road traffic regulations
CAUTION
(continued)
Do not use the Driver Information System in
its damaged state. It may cause a critical
damage to the system.
To Next Page
Loading...