Equus VI DIS - Next;Previous Station (FM and am Tuner Mode Only); Next;Previous Channel (XM Tuner Mode Only); Station Search (FM and am Tuner Mode Only); Selecting Stations;Channels Stored in the Presets

274
Voice control
Tuner mode (FM, AM and XM Satellite Radio)
Next/previous station (FM and AM
tuner mode only)
You can use the commands “Next station”
and “Previous station” to tune the unit to the
next or previous station stored in the
presets.
 Press the  button on the steering
wheel and say the desired command
after the signal tone.
The unit tunes to the desired station.
Next/previous channel (XM
®
tuner
mode only)
You can use the commands “Next channel”
and “Previous channel” to tune the unit to
the next or previous channel stored in the
channel presets.
 Press the  button on the steering
wheel and say the desired command
after the signal tone.
The unit tunes to the desired channel.
Station search (FM and AM tuner
mode only)
You can use the commands “Seek up” and
“Seek down” to start the station search. The
station search proceeds upwards or
downwards and stops at the next
receivable station.
 Press the  button on the steering
wheel and say the desired command
after the signal tone.
The unit tunes to the next receivable
station.
Selecting stations/channels stored
in the presets
You can use the command “Preset...(1-16)”
to tune the unit to a station/channel stored
in the corresponding preset.
 Press the  button on the steering
wheel and say e.g. “Preset 4” after the
signal tone.
The unit tunes to the station/channel
stored in the preset 4.
Selecting channels (XM
®
tuner
mode only)
You can use the command “Channel ...*” to
select XM
®
Satellite Radio channels
directly by the channel name.
 Press the  button on the steering
wheel and say the command
“Channel ...*” after the signal tone.
The unit tunes to the desired channel.
You can use the command “Channel...(1-
255)” to select XM
®
Satellite Radio
channels directly by the channel number.
 Press the  button on the steering
wheel and say e.g. “Channel 10” after
the signal tone.
The unit tunes to the channel 10.
You can use the command “Channel by
name” to select a channel from a picklist,
see also “Selecting a channel (XM
®
tuner
mode only)” on page 275 in the section
“Operating examples”.