EasyManua.ls Logo

Equus VI DIS - Setting the Volume; Switching to FM1;FM2 or am Mode and Switching Radio Band; Audio Settings

Equus VI DIS
317 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
33
Functional introduction
Basic functions
Setting the volume
There is one common volume setting for
the FM, AM, DISC and XM
®
Satellite Radio
signal sources.
There is also one common volume setting
for the AUX signal sources (iPod
®
, USB
and AUX). Both settings are independent
from each other.
Separate volume settings are possible
for the phone, for audible driving
recommendations and for voice control.
The respective volume can be set during
a phone call, during an audible driving
recommendation and during voice output.
The volume for audible driving
recommendations can also be set in the
navigation settings, see the chapter
“Navigation”, section “Guidance volume
settings” on page 207.
The system automatically saves the
respective setting upon setting.
On the headunit
Turn the rotary knob
.
On the steering wheel
Option 1: Briefly press the or
button one or more times.
The volume will change in small
increments.
Option 2: Press and hold the or
button.
The volume will change in large
increments.
Switching to FM1/FM2 or AM mode
and switching radio band
If Navigation, INFO or PHONE is the active
mode, switching to FM or AM mode on the
steering wheel does not switch the display,
only the audio source will be switched
accordingly.
If you want to switch the display also, you
must use the
button on the control
panel.
Option 1: Press the button.
If any other mode than FM or AM was
active before, the system will switch to
FM or AM mode.
If FM1 was active before, the system
will switch to FM2.
If FM2 was active before, the system
will switch to AM band.
If AM was active before, the system will
switch to FM1.
Option 2: Press the button on the
steering wheel repeatedly until the
system switches to FM or AM mode.
Audio settings
The audio settings include the following
functions:
Setting the balance/fader, see page 34
Setting the treble/mid/bass, see
page 35
Switching surround on/off, see page 36
Performing an audio reset, see page 36
WARNING
Driving with the volume set to such a level
that the outside sound is not audible, may
be a cause of an accident.
Set the volume to such a level, that the
outside sound is audible.

Table of Contents