Equus VI DIS - Entering a Destination Stored in the Adress Book; Suspending Route Guidance; Resuming Route Guidance

285
Voice control
Navigation mode
Entering an address
You can use the command “Enter address”
to initiate a dialog for entering the address
data for a destination.
See also “Entering a destination” on
page 287 in the section “Operating
examples”.
Entering a Point of Interest (POI) via the
phone number
You can use the command “Phone number
search” to initiate a dialog for entering a
POI using phone numbers internally stored
in the system.
See also “Entering Point of Interest (POI)
via the phone number” on page 289 in the
section “Operating examples”.
Entering a destination stored in the
Adress Book
You likewise have a number of options for
entering destinations using a destination
stored in the Address Book.
The following commands are available for
this:
 “Navigate to Address Book” or
“Navigate to ...*
1
”
See also “Entering a destination stored
in the address book” on page 290 in the
section “Operating examples”.
 “Navigate home” or “Navigate work”
See also “Entering a destination stored
in the address book” on page 290 in the
section “Operating examples”.
 “Navigate to favorite point ...(1-4).”
See also “Entering a destination stored
in the address book” on page 290 in the
section “Operating examples”.
 “Navigate to previous destination”
See also “Entering a destination stored
in the address book” on page 290 in the
section “Operating examples”.
Suspending route guidance
You can use the commando “Suspend
route guidance” to stop an active route
guidance session.
 Press the  button on the steering
wheel and say the command “Suspend
route guidance” after the signal tone.
The route guidance will be suspendend.
Resuming route guidance
You can use the command “Resume route
guidance” to resume a route guidance
session.
 Press the  button on the steering
wheel and say the command “Resume
route guidance” after the signal tone.
The route guidance will be resumed.
1. Name of the address book entry