Equus VI DIS - Switching Traffic Information On;Off; Operating Examples

287
Voice control
Navigation mode
Zooming to maximum/minimum
You can use the commands “Map zoom
maximum” or “Map zoom minimum” to
zoom the map to the corresponding scale.
 Press the  button on the steering
wheel and say the desired command
after the signal tone.
The map will be zoomed accordingly.
Zooming to the entire route
You can use the command “Display route”
to show the map display with the entire
calculated route and the Options menu.
 Press the  button on the steering
wheel and say the command “Display
route” after the signal tone.
You will see the map display with the
entire calculated route and the Options
menu.
Setting the map orientation
You can use the commands “Map north up”
or “Map heading up” to orient the map
either to the north or the direction of travel.
 Press the  button on the steering
wheel and say the desired command
after the signal tone.
The map orientation changes
accordingly.
Switching traffic information on/off
You can use the commands “Traffic
Information On” or “Traffic Information Off”
to switch displaying of traffic information on
or off.
 Press the  button on the steering
wheel and say the desired command
after the signal tone.
Operating examples
Entering a destination
 Press the  button on the steering
wheel.
# Ping %
! “Enter address.”
# “Enter address.”
Entering the state or the province
# “Please say the state or province
name.”
Ping
%
! “Michigan”
# “Michigan”
$ The first page of a picklist is displayed
for selecting the state or province.
! “Michigan”
# “Michigan”