272
Voice control
General information
Automatically activated help function
The help function is automatically activated
as soon as the voice control system
identifies a problem with the voice input.
Help is then provided in two steps:
Step 1:
The commands from the top operating
level are displayed in the teleprompter.
You now have the option of reading the
desired command and continuing the
voice input. The second step of the help
function follows if voice input is not
continued or continued incorrectly.
Step 2:
The commands are displayed in the
teleprompter and said by the voice
control system.
Calling up the help function and using it
for operation
If you call up the help function using the
command “Help”, the commands are both
displayed in the teleprompter and said by
the voice control system.
If you activate the help function and repeat
one of the commands, you can then
activate the help function again. This is how
you access the available commands from
the next operating level.
You can also show the commands from an
operating area directly using the group
commands, for example “Phone
commands”.
Operating picklists
The voice control system can display
picklists to you on the screen, for example
the channel list in the XM
®
tuner mode.
Scrolling through a picklist
You can scroll through any picklist using
the commands “Next page”, “Previous
page”, “Back”, “First Page” or “Last Page”.
You can also scroll through a list using the
controller, see chapter “Functional
introduction”, section “Lists” on page 29.
Selecting an entry in a picklist
Within picklists, you have the following two
options for selecting an entry:
Option 1: Say the contents as they are
displayed in the row.
Option 2: Say the command
“Entry...(1-8)”.
You can also select an entry in a list using
the controller, see chapter “Functional
introduction”, section “Highlighting a menu
item” on page 28.
To Next Page