48
FM and AM mode
Tuning to stations
Starting the Scan function
In the FM or AM main menu, select the
menu item
Scan.
The Scan function starts, a
corresponding Scan message is
displayed.
The Scan function will stop automatically, if
the frequency from where it has been
started is reached again.
It will also stop automatically, if you switch to
another audio/video source. After switching
back to AM/FM again, the system tunes to
the frequency from where the Scan function
has been started.
You can also stop the Scan function
manually.
Stopping the Scan function manually
Option 1: Press the controller
.
The system will stop the Scan function.
Option 2: Briefly press the or
button on the steering wheel.
The system will stop the Scan function.
Button was pressed: The system
will tune to the station stored in the
preset 16.
Button was pressed: The system
will tune to the station stored in the
preset 1.
Option 3: Press and hold the or
button on the steering wheel until the
Scan message disappears.
The system will stop the Scan function
and activate the search function.
Button was pressed: The seek
proceeds downwards and stops at the
next receivable station.
Button was pressed: The seek
proceeds upwards and stops at the next
receivable station.
To Next Page
Loading...