Cinterion
®
EHS6 AT Command Set
12.18 AT+CSMS
EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 349 of 513
Broadcast Type Messages:
0 Type not supported
1
(P)
Type supported
Notes
• If CSMS mode is switched from Phase 2+ to Phase 2 and one or more AT+CNMI Parameter are Phase 2+
specific a "+CMS ERROR: unknown error" will appear. It is recommended to switch the AT+CNMI Parameters
to Phase 2 specific values before entering Phase 2.
• Phase 2+ (<service>=1) must be set before the following features can be used:
- Configuring procedures for indicating received short messages with the AT+CNMI parameters <mt>=2 or
<mt>=3 and <ds>=1.
- Acknowledging incoming short messages with AT+CNMA.
- Receiving Status Reports and acknowledging them with AT+CNMA.
<bm>
(num)(&V)
To Next Page
Loading...
