Gemalto Cinterion EHS6 User Manual

Cinterion
®
EHS6 AT Command Set 
2.12 AT^SCFG
 EHS6_ATC_V03.001 15/12/3
Confidential / Released
Page 57 of 513
Write Command
Configure Fast Shutdown line FST_SHDN shared with GPIO4 line
AT^SCFG="GPIO/mode/FSR"[, <g_mode>]
Response(s)
^SCFG: "GPIO/mode/FSR", <g_mode>
OK
ERROR
+CME ERROR: <err>
Write Command
Configure HSIC interface shared with GPIO16 - GPIO19 lines, ASC1 lines and SPI lines MOSI, MISO, SPI_CS
AT^SCFG="GPIO/mode/HSIC"[, <g_mode>]
Response(s)
^SCFG: "GPIO/mode/HSIC", <g_mode>
OK
ERROR
+CME ERROR: <err>
Write Command
Configure Impulse Counter line (COUNTER) shared with GPIO8 line
AT^SCFG="GPIO/mode/PULSE"[, <g_mode>]
Response(s)
^SCFG: "GPIO/mode/PULSE", <g_mode>
OK
ERROR
+CME ERROR: <err>
Write Command
Configure DAC Pulse-Width Modulation lines PWM2 and PWM1 shared with GPIO6 and GPIO7 lines
AT^SCFG="GPIO/mode/PWM"[, <g_mode>]
Response(s)
^SCFG: "GPIO/mode/PWM", <g_mode>
OK
ERROR
+CME ERROR: <err>
Write Command
Configure RING0 line of ASC0 interface shared with GPIO24 line
AT^SCFG="GPIO/mode/RING0"[, <g_mode>]
Response(s)
^SCFG: "GPIO/mode/RING0", <g_mode>
OK
ERROR
+CME ERROR: <err>
Write Command
Configure SPI lines MOSI, MISO, SPI_CS shared with ASC1 lines and GPIO16, GPIO17, GPIO19 lines 
as well as SPI line SPI_CLK shared with GPIO3 and DSR0 of ASC0
AT^SCFG="GPIO/mode/SPI"[, <g_mode>]
Response(s)
^SCFG: "GPIO/mode/SPI", <g_mode>
OK
ERROR
+CME ERROR: <err>

Gemalto Cinterion EHS6 Specifications

General

Brand	Gemalto
Model	Cinterion EHS6
Category	Control Unit
Language	English