HP LaserJet Enterprise M552 - Page 276

Table 2-44 Embedded Jetdirect Menu (continued)
First level Second level Third level Fourth level Values Description
TCP/IP
(continued)
IPV4 Settings
(continued)
Manual Settings
NOTE: This menu is
available only
available when using
the Manual option
under the Cong
Method menu.
IP Address Enter the address. (Available only if the
Cong Method option
is set to the Manual
option.) Congure
parameters directly
from the printer
control panel.
Subnet Mask Enter the address.
Default Gateway Enter the address.
Default IP Auto IP*
Legacy
Specify the IP address
to default to when the
print server is unable
to obtain an IP
address from the
network during a
forced TCP/IP
reconguration (for
example, when
manually congured
to use BootP or DHCP).
NOTE: This feature
assigns a static IP
address that might
interfere with a
managed network.
Auto IP: A link-local IP
address 169.254.x.x is
set.
Legacy: The address
192.0.0.192 is set,
consistent with older
HP Jetdirect products.
Primary DNS Range: 0 – 255
Default =
xxx.xxx.xx.xx
Specify the IP address
(n.n.n.n) of a Primary
Domain Name System
(DNS) Server.
Secondary DNS Range: 0 – 255
Default = 0.0.0.0
Specify the IP address
(n.n.n.n) of a
Secondary DNS
Server.
IPV6 Settings Enable O
On*
Use this item to
enable or disable IPv6
operation on the print
server.
O: IPv6 is disabled.
On: IPv6 is enabled.
Address Manual Settings Enable
Address
Use this item to
enable and manually
congure a TCP/IPv6
address.
248 Chapter 2 Solve problems ENWW