Table 2-44 Embedded Jetdirect Menu (continued)
First level Second level Third level Fourth level Values Description
Diagnostics (M552,
M553)
(continued)
Ping Test Dest Type IPv4
IPv6
This test is used to
check network
communications. It
sends link-level
packets to a remote
network host, then
waits for an
appropriate response.
Specify whether the
target printer is an
IPv4 or IPv6 node.
Dest IPv4 Range: 0 – 255
Default = 127.0.0.1
Enter the IPv4
address.
Dest IPv6 Select from a provided
list.
Default = : : 1
Enter the IPv6
address.
Packet Size Default = 64 Specify the size of
each packet, in bytes,
to be sent to the
remote host. The
minimum is 64
(default) and the
maximum is 2048.
Timeout Default = 001 Specify the length of
time, in seconds, to
wait for a response
from the remote host.
The maximum is 100.
Count Default = 004 Specify the number of
ping test packets to
send for this test.
Select a value from 0
to 100. To congure
the test to run
continuously, select 0.
Print Results Yes
No*
Execute Yes
No*
No: Do not initiate the
selected tests.
Yes: Initiate the
selected tests.
Ping Results Packets Sent Default = 00000 Shows the number of
packets (0 - 65535)
sent to the remote
host since the most
recent test was
initiated or completed.
254 Chapter 2 Solve problems ENWW
To Next Page
Loading...