HP LaserJet Enterprise M552 - Page 284

Table 2-44 Embedded Jetdirect Menu (continued)
First level Second level Third level Fourth level Values Description
Link Speed Auto* The link speed and
communication mode
of the print server
must match the
network. The
available settings
depend on the printer
and installed print
server. Select one of
the following link
conguration
settings:
CAUTION: Changing
the link setting might
result in lost network
communications
between the print
server and networked
printer.
The print server uses
auto-negotiation to
congure itself with
the highest link speed
and communication
mode allowed. If auto-
negotiation fails,
either the 100TX Half
feature or the 10T
Half feature is set
depending on the
detected link speed of
the hub/switch port.
(A 1000T half-duplex
selection is not
supported.)
10T Half 10 Mbps, half-duplex
operation.
10T Full 10 Mbps, full-duplex
operation.
10T Auto 100 Mbps, half-duplex
operation.
100TX Half 100 Mbps, full-duplex
operation.
100TX Full Limits auto-
negotiation to a
maximum link speed
of 100 Mbps.
100TX Auto 1000 Mbps, full-
duplex operation.
256 Chapter 2 Solve problems ENWW