6
PREPARATORY PROCEDURES AND SETTING
6.3 Preparatory Procedure and Setting
6 - 23
1
OVERVIEW
2
SYSTEM
CONFIGURATION
3
SPECIFICATIONS
4
FUNCTIONS
5
ACCESS VIA NETWORK
MODULES
6
PREPARATORY
PROCEDURES AND
SETTING
7
I/O NUMBER
ASSIGNMENT
8
MEMORIES AND FILES
(5) Connecting GOT by microcomputer connection
For commands that can be used for data transfer to the GOT in microcomputer
connection, refer to the manual for the GOT used.
Figure 6.15 Microcomputer connection with GOT
Figure 6.16 Flowchart for connecting GOT by microcomputer connection
C Controller module
Development environment
(personal computer)
Ethernet
RS-232
GOT
Connection
Connect the C Controller module and GOT with an RS-232
cable.
Preparation for GOT
Preparatory procedure
Programming
Operation
1) Create GOT screens and transfer the screen data to the
GOT.
2) Configure settings on the GOT.
1) Create a user program with Workbench or Tornado.
2) Debug the user program.
3) Register the user program to the C Controller module.
4) Back up the standard RAM data not to lose them due to
expiry of battery life.
(Q12DCCPU-V only)
Manual for the GOT used
C Controller Module User's Manual
(Utility Operation, Programming)
Manual for the GOT used
( Page 8-2, Section 8.1 1))
To Next Page
Loading...
