APPENDICES
Appendix 9 Connection with GX Works2/GX Developer
Appendix 9.1 When accessing another CPU of a multiple CPU system
APPX - 31
A
I
3) Set "PLC side I/F" to "PLC module".
Set the detailed setting dialog box as follows.
• For "PLC mode", select "QCPU (Q mode)".
• The GOT (direct) transparent function cannot be used.
Do not check the box.
• To use the GOT (Ethernet) transparent function, set the GOT (Ethernet)
transparent setting dialog box as follows.
• For "PLC type", select "QnUDE(H)".
• For "IP address", set the IP address of the connecting C Controller
module.
For details on the GOT transparent, refer to the following.
GOT1000 Series Connection Manual (Mitsubishi Products)
4) Set "Other station" to "No other station".
5) For "Multiple CPU setting", set the CPU to be accessed.
To Next Page
Loading...
