Panasonic FP Series - Page 1095

Analog unit instructions
1094
Part IV Tool Instructions
Input wiring
Voltage input Current input
V 0
I 0
V 1
I 1
COM
V
I
COM
IN
OUT
Input instrument
(CH1)
Input instrument
(CH0)
V 0
I 0
V 1
I 1
COM
V
I
COM
IN
OUT
Input instrument
(CH1)
Input instrument
(CH0)
Connect input instrument between IN/V and IN/COM
terminal.
First, connect both IN/V terminal and IN/I terminal. And
then connect input instrument between it and
IN/COM terminal.
Thermocouple input
when measured at temperature higher than the
temperature of the terminal
when measured at temperature lower than the
temperature of the terminal
V 0
I 0
V 1
I 1
COM
V
I
COM
IN
OUT
(+)
(-)
(+)
Thermocouple
(CH0)
Thermocouple
(CH1)
V 0
I 0
V 1
I 1
COM
V
I
COM
IN
OUT
(-)
(+)
(-)
Thermocouple
(CH0)
Thermocouple
(CH1)
Connect IN/V terminal to the (+) side of the
thermocouple, and connect IN/COM terminal to the (-)
side of the thermocouple.
Connect IN/V terminal to the (-) side of the thermocouple,
and connect IN/COM terminal to the (+) side of the
thermocouple.
Output channel setting by DIP switch 4
0 – 20 mA -10 – +10 V
Off On Off On
ON
1
2
3
4
5
1
2
3
4
5