Panasonic FP Series - Page 1287

Appendix Programming Information
1286
No.
Name Default Values
402 Pulse catch input: X0 Disable Disable/Enable
402 Pulse catch input: X1 Disable Disable/Enable
402 Pulse catch input: X2 Disable Disable/Enable
402 Pulse catch input: X3 Disable Disable/Enable
402 Pulse catch input: X4 Disable Disable/Enable
402 Pulse catch input: X5 Disable Disable/Enable
402 Pulse catch input: X6 Disable Disable/Enable
402 Pulse catch input: X7 Disable Disable/Enable
403 Interrupt input:
X0
Interrupt 0
Unused Rising edge/Falling edge
403 Interrupt input:
X1
Interrupt 1
Unused Rising edge/Falling edge
403 Interrupt input:
X2
Interrupt 2
Unused Rising edge/Falling edge
403 Interrupt input:
X3
Interrupt 3
Unused Rising edge/Falling edge
403 Interrupt input:
X4
Interrupt 4
Unused Rising edge/Falling edge
403 Interrupt input:
X5
Interrupt 5
Unused Rising edge/Falling edge
403 Interrupt input:
X6
Interrupt 6
Unused Rising edge/Falling edge
403 Interrupt input:
X7
Interrupt 7
Unused Rising edge/Falling edge
If the same input has been set as high-speed counter input, pulse catch
input or interrupt input, the following order of precedence is effective:
High-speed counter  Pulse catch  Interrupt.
If reset input settings overlap for channel 0 and channel 1, the channel 1
setting takes precedence. If reset input settings overlap for channel 2 and
channel 3, the channel 3 setting takes precedence.
The input modes two-phase, incremental/decremental, or
incremental/decremental control require a second channel. If channel 0 or
channel 2 have been set to one of these modes, the settings for channel 1
and channel 3, respectively, will be invalid.
The settings for pulse catch inputs and interrupt inputs can only be
specified in the system registers.
TOOL Port
No. Name Default Values
412 TOOL port - communication mode MEWTOCOL-COM
Slave
MEWTOCOL-COM
Slave/Program
controlled
410 TOOL port -station number 1 1–99
415 TOOL port - baud rate 115200 baud 115200/57600/38400/
19200/9600/4800/240
0 baud
413 TOOL port - sending data length 8 bits 7 bits/8 bits