Chapter 2 Installation and Configuration
Rack Mounting the SuperLoader
SuperLoader User’s Guide 19
General
Preparation for
Rack Mount
Installation 2
Take the following general safety steps before beginning either rack
mount installation.
1 Lower the cabinet feet.
2 Extend the cabinet anti-tip device, if available.
3 Ensure that the cabinet and all rack mounted equipment have a
reliable ground connection.
4 Verify that the total current of all rack mounted components
(including the SuperLoader) will not exceed the current rating of the
power distribution unit or outlet receptacles.
5 Secure the help of at least one other person. At least two people are
required to safely install the SuperLoader into a rack cabinet.
Stationary Rack
Mount Installation 2
This section describes the steps for attaching the SuperLoader directly to
the rails of a rack.
1 Make sure you have the following tools and parts:
• #2 PHILLIPS
®
screwdriver
• Level
• The following SuperLoader accessory kit parts (see figure 11
):
• Four SuperLoader brackets (two long and two short to
accommodate different rack depths)
Use the short SuperLoader brackets (74-60604-03) unless the
distance from the front mounting rail to the rear mounting
rail is less than 30.25 in. (76.84 cm).
• Two support brackets (74-60605-01)
• Eight 10-32 x 1/4 inch button head screws for the support
brackets (four per support bracket)
Warning: Failure to take these safety steps may result in
personal injury or equipment damage.
Caution: Do not remove the top cover of the SuperLoader
during the installation process. Removing the top
cover could result in damage to the SuperLoader.
To Next Page
Loading...
