Quantum Superloader 3 - Subnet Mask; Figure 27 Main Menu (LCD); Figure 28 Set Subnet Mask

Chapter 2 Installation and Configuration
Setting Ethernet
SuperLoader User’s Guide 37
Subnet Mask 2 Creating a subnet mask is a method to split IP networks into a series of
subgroups, or subnets, to improve performance and security.
To Set a Subnet Mask: 2
1 On the main menu, scroll to
Configuration, then press Enter.
Figure 27 Main Menu
(LCD)
2 On the Configuration menu, scroll to Ethernet, then press Enter.
3 On the Ethernet submenu, scroll to
Set Subnet Mask, then press Enter.
4 Scroll to
Static IP, then press Enter. The cursor automatically appears
at the first digit.
Figure 28 Set Subnet
Mask
5 At each position of the Subnet Mask address, use the up and down
arrows to change the value of each digit. Press
Enter to advance the
cursor to the next digit.
Note: If you make a mistake, press
Escape to backspace to the
digit you want to change.
Status
Commands
Configuration
Diagnostics

Subnet Mask Address
255.255.255.000