Chapter 2 Installation and Configuration
Setting the Change Mode
SuperLoader User’s Guide 47
2 On the Configuration menu, scroll to Change Mode, then press Enter.
The mode options appear. A check mark appears next to the
currently enabled mode.
3 Do one of the following:
• To leave the mode the same, press
Escape.
• To modify the change mode, scroll to the mode to which you
want to set the SuperLoader and press
Enter. Reboot to enable new
mode
appears on the LCD.
• Press and hold the power button on the front panel until
System Shutdown Please Wait appears on the LCD. Power Off
appears on the LCD and the SuperLoader shuts off.
• Press the power button again to power up the SuperLoader.
The new control mode is now in effect.
Sequential Mode
Operations 2
If you enable Sequential Mode, you must use the Sequential Ops submenu
under the Commands menu to operate the SuperLoader after you reboot.
•The
Start command allows you to load the first cartridge.
•The
Resume command allows you to continue from the next unused
slot, if a user stopped the cycle.
•The
Stop command allows you to stop the cycle.
Note: When you enable
Sequential Mode, the loader device no
longer appears on the SCSI bus; only the tape drive
appears.
To Next Page
Loading...
