Quantum Superloader 3 - Set the Cleaning Mode; Set the Magazines

Chapter 4 SuperLoader Operation
Configurations Page
SuperLoader User’s Guide 113
Set the Cleaning
Mode 4
To enable the Auto Clean function, you must also designate a full slot for
the cleaning tape cartridge. If a slot has not been designated, the box
displays
None.
To designate the cleaning tape slot: 4
1 Load a cleaning tape into an empty slot using the Commands page
(see Commands Menu
on page 74).
2 Enable
Auto Clean.
To Set Auto Clean: 4
1 On any On-board Remote Management page, click
Configurations.
2 If a check mark appears in the box next to
Auto Clean, the option is
enabled. To disable AutoClean, click the box to remove the check
mark.
If no check mark appears in the box next to
Auto Clean, the option is
disabled. To enable
Auto Clean, click the box to enter a check mark.
3 Click
submit.
Set the Magazines4 This setting is used to report the number of storage elements and the
element address to the SCSI host. This setting must match the physical
configuration in order for correct information to be reported. This setting
only affects the information reported to the SCSI host. This setting does
not affect the access to magazines slots from the front panel or On-board
Remote Manager. Those interfaces are based on the physical
configuration.
When configured for
Both magazines, the SuperLoader always reports 16
storage elements to the SCSI host. This allows the removal and reinstall of
magazines without affecting what is reported to the host. When
configured for
Left or Right, the SuperLoader will always report eight
storage elements to the SCSI host.
Note: If
Auto Clean is disabled, the cleaning tape will be
automatically ejected via the mailslot.