Quantum Superloader 3 - Figure 105 Event Error Log; Table 22 Event Error Log Field Descriptions

Chapter 5 Troubleshooting
Tape Drive Error Logs
SuperLoader User’s Guide 175
Figure 105 Event
Error Log
Table 22 describes each of the Event Error log’s specialized fields.
Table 22 Event Error
Log Field Descriptions
In addition to the specialized fields, each Event Error log has specific
information about the cause and suggested actions to follow for
troubleshooting errors. This information can be found in the block
descriptors of each log. Use the following sections to find information on
each Event Error log:
• A400: Read Error
• A401: Write Error on page 179
• A402: Drive Error
on page 182
• A403: Loader Log
on page 186
• A404/A405: Calibration
on page 188
• A407: Directory Read
on page 191
• A408: Directory Write
on page 197
• A500: SDLT Hard Read Error
on page 201
Field Description
V Number The version of firmware the drive was using when the event was logged.
Date A reference date for when the firmware was created by Quantum
Time Stamp The total time in which the tape drive has had power applied to the tape
drive, since the last power cycle. This is hours, minutes, seconds, and
milliseconds. There is no date associated with the power up time.
V number
Date
Time stamp
Event Log # 3 - Event: A401 [V80-0 4-Aug-1998] 000:03:52.153 POH/PC = 340/16
110013B9 571E0101 00400000 00130000 02D10000 00440000 00000000 220024CA
00000000 04720000 00000000 00000000 00000000 00000000 00000000 00000000
00000000