Chapter 4 SuperLoader Operation
Use of Magazines and Magazine Blanks
SuperLoader User’s Guide 87
To Unload Cartridges from a Fully Ejected Magazine: 4
You can remove a cartridge in the same manner as you insert it. Use the
knobs to center the desired slot(s) in the openings on the side of the
magazine. Using your thumb and index finger, pull out the cartridge.
You will feel a small resistance but continue to pull the cartridge until it
comes free.
To Load and Unload Cartridges from a Partially Ejected Magazine: 4
You can conveniently load and unload a cartridge from the magazine
without fully removing the magazine.
1 Pull the ejected magazine until the large upper slot is accessible.
Figure 61 Upper Slot
of Magazine (SDLT
Shown)
2 Rotate the desired slot into position (centered in the opening). Either
load or unload a cartridge to that location. Do not expose more than
the large upper opening when manually operating the magazine.
Caution: When unloading or loading cartridges from a partially
ejected magazine, do not manually operate the
magazine when it is positioned between the two
marks on the top cover. Manually operating the
magazine in this location can cause damage to the
SuperLoader and magazine.
To Next Page
Loading...
