Quantum Superloader 3 User Manual

Chapter 2 Installation and Configuration
Setting the Time
44 SuperLoader User’s Guide
Figure 37 Setting a
Time Zone (Minutes)
5 Scroll to set the number of minutes’ difference between your local
time and GMT, then press
Enter. The new time zone is set.
6 Press
Escape or Enter as necessary to return to the main menu.
To Set the Date and Time: 2
1 On the main menu, scroll to
Configuration, then press Enter.
Figure 38 Main Menu
(LCD)
2 On the Configuration menu, scroll to Time, then press Enter.
3 On the Time submenu, scroll to
Set Date/Time, then press Enter. The
Date/Time screen appears, allowing you to set the date and time. The
cursor automatically appears at the first digit.
Time Zone: set hrs
GMT -6:00
Status
Commands
Configuration
Diagnostics


Quantum Superloader 3 Specifications

General

Product Type	Tape Autoloader
Number of Tape Drives Installed	1
Number of Cartridge Slots	8
Tape Technology	LTO Ultrium
Data Compression Ratio	2:1
Native Capacity	12 TB
Compressed Capacity	24 TB
Interfaces	SAS
Humidity	20% to 80% non-condensing
Operating Temperature	10°C to 35°C
Supported Media	LTO-5, LTO-4