Quantum Superloader 3 - DLT Drive Diagnostic Results Logs; Figure 123 POST Failures Event Log; Table 40 POST Failures Event Log Field Description

Appendix A Basic Information Logs
Tape Drive Logs
240 SuperLoader User’s Guide
Figure 123 POST
Failures Event Log
Table 40 describes Post Failures Event Log fields.
Table 40 POST
Failures Event Log
Field Description
DLT Drive
Diagnostic Results
Logs
1
Each time the SuperLoader or tape drive runs an internal diagnostic, it
logs the results of that test. If a
SCSI SEND DIAGNOSTIC command was
issued to the drive, the results of the test would be seen in both the SCSI
response to the command as well as an entry in the log page (see
figure 124
).
Field Description
Last Fail The type of failure that was experienced.
Last fail
Event Log # 4 - PO / ST Error - Last Fail: 88021950 POH / PC = 527 / 71
70000000 00000000 00000000 00000000 00000000 00000000 00000000 00000000
00000000 00000000 00000000 00000000 00000000 00000000 00000000 00000000