Chapter 2 Installation and Configuration
Setting Ethernet
SuperLoader User’s Guide 39
4 At each position of the gateway address, use the up and down arrows
to change the value of each digit. Press
Enter to advance the cursor to
the next digit.
5 When you have advanced through all of the digits of the IP address,
the SuperLoader displays
Enter to save.
6 Press
Enter. GW changed to appears on the display. You do not need to
reboot the SuperLoader.
7 Press
Escape or Enter to return to the Ethernet submenu.
Setting the SNMP
Server 2
An SNMP server monitors a network by processing reporting activity in
each network device (hub, router, bridge, and so on). The server uses this
information to define what is obtainable from each device and what can
be controlled (turned off, on, and so forth).
To Set an SNMP Server: 2
1 On the main menu, scroll to
Configuration, then press Enter.
Figure 31 Main Menu
(LCD)
2 On the Configuration menu, scroll to Ethernet, then press Enter.
3 On the Ethernet submenu, scroll to
Set SNMP Server, then press Enter.
The cursor automatically appears at the first digit.
Note: If you make a mistake, press
Escape to backspace to the
digit you want to change.
Status
Commands
Configuration
Diagnostics
To Next Page
Loading...
