Chapter 2 Installation and Configuration
Powering On the SuperLoader
SuperLoader User’s Guide 29
Once the power-on sequence completes and the SuperLoader is
ready, the LCD lists the SuperLoader options that are present and the
Ready LED is steady green.
Figure 19 Sample Idle
Screen Display
(SuperLoader LTO
illustrated)
2 When you first power on the SuperLoader, it automatically runs a
POST. During the POST, the left (green) LED flashes. After the POST,
the left (green) and right (amber) LED flash alternately back and
forth. Do one of the following:
• If the SuperLoader powers on successfully, continue configuring
the SuperLoader (see Configuration
).
Note: When the SuperLoader is idle for a while, the company
logo appears, the LCD backlight turns off (into power-save
mode), and the drive type (if known) or the date and time
appears.
Note: After powering up the SuperLoader using the method
described above, you should use the switch on the front to
power off and on the SuperLoader.
HP Ultrium
To Next Page
Loading...
