Quantum Superloader 3 - Figure 73 Accessing the Backup Copy of Firmware (Superloader DLT Shown)

Chapter 4 SuperLoader Operation
Updating the System
SuperLoader User’s Guide 101
Figure 73 Accessing
the Backup Copy of
Firmware (SuperLoader
DLT Shown)
To Change the Position of the Jumpers: 4
1 Remove the DCA. For more information on this procedure, refer to
the
SuperLoader Drive Carrier Assembly (DCA) Replacement Quick Start
Guide
.
2 Change the jumpers from vertical to horizontal or horizontal to
vertical.
3 Reinstall the DCA.
The SuperLoader will use the firmware from the backup copy. When the
firmware backup copy is up and running, this copy becomes the primary
and the SuperLoader runs from this location until a new firmware update
is again executed.
If jumpers are vertical, change
them to horizontal.
If jumpers are horizontal,
change them to vertical.