Quantum Superloader 3 - Software

Chapter 3 Tape Cartridge Use
Tape Drive Cleaning Methods
SuperLoader User’s Guide 67
Before you enable the Auto Clean option, you must designate which slot
contains the cleaning cartridge and load the cleaning cartridge into that
slot. If you have not done this, the SuperLoader will not allow you to
enable Auto Clean.
To Set Auto Clean: 3
1 On the main menu, scroll to
Configuration, then press Enter.
2 On the Configuration submenu, scroll to
Cleaning Tape, then press
Enter.
3 On the Cleaning Tape submenu, scroll to
Auto Clean On/Off. If Auto
Clean is enabled, the menu item appears as
Auto Clean On. If Auto
clean is disabled, it appears as
Auto Clean Off.
4 To change the setting, press the up or down scroll key once, then
press
Enter.
Software 3 Set the cleaning option in your software application (if available) so that
the software monitors drive cleaning. If your application software
supports automatic cleaning, store a cleaning cartridge in the slot
specified by the application.